#Travel trailer backup camera install#

Using An RV Backup Camera As A Security Camera See Also: Why Is The Garmin RV GPS Navigation System The Best? RV backup cameras can also be used as security cameras if you want to see what’s going on around your camper. If you want to use the RV backup camera while you’re driving the running lights will need to be on. One thing to note is that because the backup camera is drawing power from a running light you will need to turn on the lights or go into reverse in order to get it to turn on. There are usually a few mounting options included like a suction cup windshield mount or adhesive dash mount. The backup camera monitor goes inside the cab of your vehicle and is powered by a 12 volt plug. Once everything’s installed on the RV, make sure you reseal around the running light and the camera mounting plate to prevent leaks.

#Travel trailer backup camera install#

You can now install the RV backup camera’s mounting plate per the instruction that came with it. Then pull the wires out of the small hole you drilled. Once you’ve connected the camera wires to the running light feed them into the wall through the hole behind the running light. To install, simply drill a small hole about 2 inches below the running light you are going to be using for power. The video signal is transmitted wirelessly so you won’t need to run any cables to the front of the RV. Since the power supply can be easily accessed via a running light, installing an RV backup camera on older RVs and trailers is pretty easy. See Also: Best Wireless RV Backup Cameras & Systems Reviewed Can I Install a Wireless Backup Camera on an Old RV? Note that some camper trailers don’t have the upper tail/running lights wired into the reverse lighting system and you will need to manually turn on the lights to use the camera. In most cases, the running lights of your camper have to be on in order for the RV backup camera to get power, or you need to be in reverse. It also means the camera won’t stay on when the engine is turned off and drain the battery.

This allows for easy installation that doesn’t require running wires through the entire camper. Usually, it’s the center one that’s directly above where the backup camera is installed. So far, the best way to get power to a wireless RV backup camera is to connect it to one of the running/reverse lights on the back of an RV. How Do I Make It So My RV Backup Camera Stays On All The Time? Connecting an RV Backup Camera to Power